capture DirectShow using command line - corrupted file

[kingston11]

Hey,

I want to capture video using EasyCap device. I managed to capture using a command line a few minutes, it works together with the audio. But when I open the file it shows some frames of the video then ran and got stuck.

I attach here the command line I work with it, can you help me:

Code: Select all

"C:\Program Files\VideoLAN\VLC\vlc.exe" dshow:// --dshow-vdev="Syntek STK1150" --dshow-adev= --dshow-caching="300" --dshow-aspect-ratio="16:10" --sout=#transcode{vcodec=h264,vb=800,ab=128,vfilter=canvas{width=640,height=480},acodec=mpga}:standard{access=file,mux=mp4,dst="C:\video_cap\test.ts"}

I do not have to do the conversion of the video immediately during capture. But I could not do otherwise.

Thank you all

[kingston11]

What to write for computer capture only what is shown without doing TRANSCODE?

Thanks

[Jean-Baptiste Kempf]

You must transcode.

[kingston11]

Thanks for the response!

What am I doing wrong file because it jumps back and forth and is displayed incorrectly? This can be a problem that needs a more powerful?