I have 2 Windows 7-64 PCs, 1 with a Datapath capture card as the streaming source at 1920x1080p signal from the capture card with VLC as a stream server,
and the other with VLC player to show what is being captured on PC1 input card.
I have it working with HTTP and transcoding with MPG2 + MPGA (TS), but the quality is bad.
My question is what is the best way to set up transport and transcode with best image quality? CPU consumption doesnt matter.
I have had good luck with RTP on the streamer when I show locally, but I cannot get the player to to connect..
Thanks so much for any insight
What is best settings?
Forum rules
Please post only Windows specific questions in this forum category. If you don't know where to post, please read the different forums' rules. Thanks.
Please post only Windows specific questions in this forum category. If you don't know where to post, please read the different forums' rules. Thanks.
-
Jean-Baptiste Kempf
- Site Administrator
- Posts: 37523
- Joined: 22 Jul 2005 15:29
- VLC version: 4.0.0-git
- Operating System: Linux, Windows, Mac
- Location: Cone, France
- Contact:
Re: What is best settings?
Use h264 and a higher bitrate.
Jean-Baptiste Kempf
http://www.jbkempf.com/ - http://www.jbkempf.com/blog/category/Videolan
VLC media player developer, VideoLAN President and Sites administrator
If you want an answer to your question, just be specific and precise. Don't use Private Messages.
http://www.jbkempf.com/ - http://www.jbkempf.com/blog/category/Videolan
VLC media player developer, VideoLAN President and Sites administrator
If you want an answer to your question, just be specific and precise. Don't use Private Messages.
Return to “VLC media player for Windows Troubleshooting”
Who is online
Users browsing this forum: No registered users and 34 guests