Hello,
I receive a TS (which contains several programs) over Multicast Streaming, I then use that TS as input of a mosaic that I build through VLC Mosaic Wizard.
Therefore, I would like to able to select a single program for each mosaic's cell.
Hereafter the VLM code which automatically generated, when I set up the input parameters for each mosaic's cell.
new CP2 broadcast enabled
setup CP2 input "udp://@224.0.0.9:2009"
setup CP2 output #duplicate{dst=mosaic-bridge{id=CP2,width=210,height=163},select="video",dst=bridge-out{id=2},select="audio"}
As you can see, there is no parameter which specifies the input program (inside the multicast TS) that is selected.
I notice that, is is always the video of the first program (i.e with the smallest service id) which always displayed.
Any help would be really appreciated.
Best Regards.