I want to speed up the playback of video and audio to allow a viewer to scan forward. When I set the value of the activex control's input.rate to some value other than 1.0 the audio is muted and I can not turn it back on. Is there any way to prevent this? Can I get the audio rate to increase equally and just sound "chipmunky" ?
Thanks very much....
RKM
Possible to get audio when axVLCPlugin21.input.rate changes
-
corvusvideo
- Blank Cone
- Posts: 29
- Joined: 03 Mar 2008 16:14
-
corvusvideo
- Blank Cone
- Posts: 29
- Joined: 03 Mar 2008 16:14
Re: Possible to get audio when control.input.rate is != 1.0 ???
I have tried everything I can think of but no luck getting sound except at a rate of 1.0 
Can anyone tell me definitively whether I am spinning my wheels here or whether there is some way to do this?
Thanks....
Can anyone tell me definitively whether I am spinning my wheels here or whether there is some way to do this?
Thanks....
-
Jean-Baptiste Kempf
- Site Administrator
- Posts: 37523
- Joined: 22 Jul 2005 15:29
- VLC version: 4.0.0-git
- Operating System: Linux, Windows, Mac
- Location: Cone, France
- Contact:
Re: Possible to get audio when axVLCPlugin21.input.rate changes
Only 0.9.0 will play sound if rate != 1.0
Jean-Baptiste Kempf
http://www.jbkempf.com/ - http://www.jbkempf.com/blog/category/Videolan
VLC media player developer, VideoLAN President and Sites administrator
If you want an answer to your question, just be specific and precise. Don't use Private Messages.
http://www.jbkempf.com/ - http://www.jbkempf.com/blog/category/Videolan
VLC media player developer, VideoLAN President and Sites administrator
If you want an answer to your question, just be specific and precise. Don't use Private Messages.
-
corvusvideo
- Blank Cone
- Posts: 29
- Joined: 03 Mar 2008 16:14
Re: Possible to get audio when axVLCPlugin21.input.rate changes
Thank you for your reply! I was using 8.6. Thanks again....
Who is online
Users browsing this forum: No registered users and 6 guests