Need help with Modules/marq

[AviatorCJ]

Hello Please help.
When I create a stream, I get the following Generated stream output string:

Code: Select all

:sout=#http{mux=ps,dst=:11341/} :sout-keep

How to correctly insert in this string a command "marq"?
I want to put the text on this stream.

[Rémi Denis-Courmont]

You cannot add a marquee in this case, as you are not (re)encoding the video signal.

[AviatorCJ]

Necessarily need to (re)encoding from one video format to another? The input stream that I broadcast is already in the correct format.

[Rémi Denis-Courmont]

You cannot change the video content without reencoding. And yes, it is expensive and might incur a loss of quality.

[AviatorCJ]

Too bad. Are there other ways to put text on the video stream?

[Rémi Denis-Courmont]

You could theoretically mux an extra subtitle track. But there is no warranty that the receiver will show it.

[AviatorCJ]

I broadcast rtp :/ /-stream instead of a file. It can be put subtitles?

[Rémi Denis-Courmont]

It's irrelevant how you output. Text can only be burnt into decoded video. If you do not decode and reencode the video, you cannot burn text into it; you can only add a subtitle track and hope that the receiver will enable subtitles...

[AviatorCJ]

Can you give an example how to add a subtitle in this Generated stream output string?

Code: Select all

:sout=#http{mux=ts,dst=:11341/} :sout-keep