transcoding from the VLM API in vlc 0.9.0

[nonono]

Hello!!
i'm writting an application that uses vlc transcoding and steaming capabilities throught the VLM API. So i'm using vlm from the source code calling functions like vlm_ExecuteCommand, vlm_delete and so on..

As i was trying to transcode and stream a mpg video comming from the network interface (udp://@1245) i noticed that the transcode part of following "sout" has been ignored by vlc or vlm:

#transcode{vcodec=mp4v, vb=256}:std{access=udp, mux=ts, dst=10.123.33.120}.

This command could stream the video but it hasn't been transcoded. i tested it with the telnet interface from the console and also directly through the vlc command line and it worked fine in both cases.

hier is the complete steps; assuming the stream is comming from port 1245

(using vlc 0.9.0-svn grischenko)

new bob broadcast enable
setup bob input udp://127.0.0.1:1245
setup bob output #transcode{vcodec=mp4v, vb=256}:std{access=udp, mux=ts, dst=10.123.33.120}
control bob play

I will appreciate any suggestion

Thank