Is it possible to find out if a variable of an access module was set via command line or via predefined default value?
I want to give higher priority to variable values specified on the command line rather than in the configuration file, but in order for this to work, I need to know if a variable was set on the command line or not.
Command line or config file?
-
kostyan
- Blank Cone
- Posts: 34
- Joined: 15 Jun 2012 12:07
- VLC version: 2.1.0-git
- Operating System: Linux
- Location: Berlin, Germany
Command line or config file?
Konstantin Miller
Technische Universität Berlin
Technische Universität Berlin
-
Jean-Baptiste Kempf
- Site Administrator
- Posts: 37523
- Joined: 22 Jul 2005 15:29
- VLC version: 4.0.0-git
- Operating System: Linux, Windows, Mac
- Location: Cone, France
- Contact:
Re: Command line or config file?
Isn't that the default behaviour anyway?
Jean-Baptiste Kempf
http://www.jbkempf.com/ - http://www.jbkempf.com/blog/category/Videolan
VLC media player developer, VideoLAN President and Sites administrator
If you want an answer to your question, just be specific and precise. Don't use Private Messages.
http://www.jbkempf.com/ - http://www.jbkempf.com/blog/category/Videolan
VLC media player developer, VideoLAN President and Sites administrator
If you want an answer to your question, just be specific and precise. Don't use Private Messages.
-
kostyan
- Blank Cone
- Posts: 34
- Joined: 15 Jun 2012 12:07
- VLC version: 2.1.0-git
- Operating System: Linux
- Location: Berlin, Germany
Re: Command line or config file?
In fact, I was thinking about using a separate configuration file just for my module, but probably you are right and I should use the VLC configuration file instead.
Konstantin Miller
Technische Universität Berlin
Technische Universität Berlin
Return to “Development around libVLC”
Who is online
Users browsing this forum: No registered users and 40 guests