Kfir error

Discussion on the (deprecated) VideoLAN Server application as well as the miniSAPserver stream announcer. This is not about VLC!
Forum rules
Please do not post VLC related questions in this forum category. See the Forum Rules for more information.
bschuele

Kfir error

Postby bschuele » 16 Jan 2004 11:16

Hello,

i try to setup a vls with a kfir board to stream over network. If a setup the kfir board to put out Programm Stream it works ok. But if a change to Transport Stream i become always this error on startup:

VideoLAN Server v 0.5.5 (Jan 16 2004) - (c)1999-2003 VideoLAN
2004-01-16 10:43:20 [ERROR/kfir] Unable to start program video
2004-01-16 10:43:20 [ERROR/kfir] Error: unable to start streaming of program video
Error: Unable to create thread
Error: Could not open file '': No such file or directory

Thanks for any help

Benjamin Schüle

i loaded the kfir driver with:
insmod kfir vidinput=0 vidsize=0x26 vidinmode=0 vidoutmode=1 sndfreq=7 streamtype=4 vidrate=4000000

my vls.cfg is:
# vls.cfg (VLS configuration file)
# Example of the VideoLAN HOWTO for the Visiontech Kfir encoding card
# vls configuration file (Example)

# Application wide settings
BEGIN "Vls"
LogFile = "vls.log" # log file
ScreenLog = "enable" # log to the console
SystemLog = "disable" # log to the systemlog
END

# Security informations :
#
# The section "Groups" describes which group is allowed to use which command.
# Each user who belongs to the 'master" group has all the power on the server.
# Each one who belongs to the "monitor" group is a "read-only" user.
BEGIN "Groups"
# --- Format:
# groupname = "cmd1|cmd2|..."
# --- Example:
monitor = "help|browse|logout"
master = "help|browse|start|resume|suspend|stop|shutdown|logout|config|program|input|channel|show"
END

# The section "Users" describes each user
# Use "mkpasswd" to generate the encrypted password.
BEGIN "Users"
# --- Format:
# username = "encryptedpassword:group"
# --- Example:
monitor = "3BcKWoiQn0vi6:monitor" # password is 'monitor'
bozo = "JKg2TpPerilnw:master" # password is 'bozo'
END

# Telnet Administration
BEGIN "Telnet"
# Domain = "Inet6" # Inet4 or Inet6
LocalPort = "9999" # Port to use for that purpose
Use = "true"
END

BEGIN "Inputs"

kfir = "video"

END

BEGIN "kfir"

# Visiontech Kfir device
Device = "/dev/video"

# Stream type (default is "Mpeg2-PS")
Type = "Mpeg2-TS"

END

BEGIN "Channels"

channel1 = "network"

END

BEGIN "channel1"

# Unicast or multicast IP address
DstHost = "192.168.1.13"

# Destination port
DstPort = "1234"

# If it's a multicast IP address, uncomment the line below
#Type = "multicast"

# If it's a multicast IP address, set the "Time To Live" below
#TTL = "12"

END

BEGIN "LaunchOnStartUp"

command1 = "start video channel1 kfir"

END

Return to “VideoLAN Server and miniSAPserver”

Who is online

Users browsing this forum: No registered users and 44 guests