The VideoLAN Forums

Hi sorry if this is in the incorrect part of the forum.

I have Windows XP SP3,
A Hauppage WinTV Nova T-stick 3,
& VLC.

The problem I have been experiencing is: Open VLC (I have version 1.0.3 goldeneye), Media > Open Capture Device > Select DVB Direct Show > under the options section fill in the Transponder / Multiplex frequency as 802 kHz, then Click the Advanced Options button to input the Transponder / Multiplex frequency as 802000HZ, then click OK, then click play and nothing happens


This used to work without any problems..

When I go to try input / check the settings, the advanced input of 802000 Hz has returned to 0

Help?

Thanks,
bf1

Multiplex frequency as 802000HZ

Use 802000000.
And also you must specify the bandwidth, usually 7 or 8.

Thanks but no luck

Tried the above by copying in then going Media > Open Location from Clipboard and didn't work

Checking under the Capture Device Tab, the correct setting are there but on pressing the advanced options button, again the advanced settings are incorrect / reverted to the default zero values

I'm having the same problems with a nova td usb stick.
Did you get any joy in the end?