Setting DirectShow capture options from CLI
Posted: 20 Jan 2005 07:20
by jcsston
Is it possible to set the DirectShow capture property pages options from CLI?
For the use of tuning, setting the correct video size, and correct audio input for automated recording?
Posted: 20 Jan 2005 18:01
by The DJ
vlc --longhelp --advanced
also see
http://www.videolan.org/doc/streaming-howto/en/
Not quite finished yet, but most of the basics are there.
Posted: 21 Apr 2005 06:52
by MJK
I looked at the DirectX video input section of that long help (thanks!), and I have a question.
On my DirectShow-compatible capture card (ATI TV Wonder Elite), I want to be able to capture from the S-Video input. If I use dshow-config (or check the box in the GUI), then I get a sequence of dialogs when I go to start the stream, and one of them allows me to adjust the "Crossbar", to select the S-Video input.
Is there any way to make this selection from the command line?