Page 1 of 1
http interface and version 0.7.2
Posted: 12 Jul 2004 15:49
by bentzy
I would like to launch vlc as I do with 0.7.0 version
so I don't see the panel at all
> vlc -I http --http-host host:port
Unfortunately I use the same command but the wxWindows panel pops up.
Is there any way to avoid this??
thanks!
Re: http interface and version 0.7.2
Posted: 12 Jul 2004 16:41
by fkuehne
Why do not you use the command line options "--intf=" and "--extraintf=" to launch the http interface and by your opinion any other additional interface? This should be a lot simplier and more reliable.
You can add your http-intf options afterwards, but you should have a look at the VLC user guide for correct syntax (see documentation page).
Regards.
Posted: 12 Jul 2004 17:06
by bentzy
the same occurs when
>vlc --intf=http !!??
Posted: 12 Jul 2004 18:13
by markfm
You might want to try again, using:
vlc -vvv --intf http
When I did the above, then opened a browser to http://my_ip_address:8080
It popped open a VLC HTTP control interface.
(Maybe it's the "=" that messed it up for you?)
Posted: 13 Jul 2004 11:04
by bentzy
Now look, it is very strange
>vlc -I http --http-host host:port
>vlc --intf=http
>vlc -vvv --intf http
All of them works!!,
but when I change to other PC?!
At the first PC I tried it, they also launch the wxWindows interface.
Any ideas??
THANX!
Posted: 13 Jul 2004 12:38
by The DJ
You should delete the preferences on that other machine AND completly remove the VLC installation by hand and reinstall. Maybe something is wrong.
Posted: 13 Jul 2004 12:57
by bentzy
Thanks,
I just found the solution changing the preferences.
I don't "install it", i just compiled it succesfully after many trials...
Where the preferences settings are saved???
Thanks again!
Posted: 13 Jul 2004 13:02
by markfm
Take a look at
http://videolan.org/doc/
The FAQ talks about where the vlcrc file is stored.