The VideoLAN Forums

Hi all,

For some time now I have been checking the forum and try-out settings but cannot seem to figure out how I capture video and force stream 0 as video and audio as stream 1.
During capture I can verify codec info and it is ok (stream 0 is video), but after ending the capture and viewing the end-result stream 0 is audio and stream 1 is video.....
I do not know how to correct and I have to use freemake to convert after the capture to be able to play on my philips tv.
Please help and guide me to the correct setting in either command line or gui preferences.

Did you ever find a solution to this? I am also looking for a way to do this. Either that or a command line tool that will automatically switch the stream assignments after the intial record/encode.