Is it possible to set the DirectShow capture property pages options from CLI?
For the use of tuning, setting the correct video size, and correct audio input for automated recording?
Setting DirectShow capture options from CLI
-
The DJ
- Cone Master
- Posts: 5987
- Joined: 22 Nov 2003 21:52
- VLC version: git
- Operating System: Mac OS X
- Location: Enschede, Holland
- Contact:
vlc --longhelp --advanced
also see http://www.videolan.org/doc/streaming-howto/en/
Not quite finished yet, but most of the basics are there.
also see http://www.videolan.org/doc/streaming-howto/en/
Not quite finished yet, but most of the basics are there.
Don't use PMs for support questions.
I looked at the DirectX video input section of that long help (thanks!), and I have a question.
On my DirectShow-compatible capture card (ATI TV Wonder Elite), I want to be able to capture from the S-Video input. If I use dshow-config (or check the box in the GUI), then I get a sequence of dialogs when I go to start the stream, and one of them allows me to adjust the "Crossbar", to select the S-Video input.
Is there any way to make this selection from the command line?
On my DirectShow-compatible capture card (ATI TV Wonder Elite), I want to be able to capture from the S-Video input. If I use dshow-config (or check the box in the GUI), then I get a sequence of dialogs when I go to start the stream, and one of them allows me to adjust the "Crossbar", to select the S-Video input.
Is there any way to make this selection from the command line?
Return to “General VLC media player Troubleshooting”
Who is online
Users browsing this forum: No registered users and 24 guests