Page 1 of 1
Possible to get audio when axVLCPlugin21.input.rate changes
Posted: 03 Mar 2008 16:20
by corvusvideo
I want to speed up the playback of video and audio to allow a viewer to scan forward. When I set the value of the activex control's input.rate to some value other than 1.0 the audio is muted and I can not turn it back on. Is there any way to prevent this? Can I get the audio rate to increase equally and just sound "chipmunky" ?
Thanks very much....
RKM
Re: Possible to get audio when control.input.rate is != 1.0 ???
Posted: 05 Mar 2008 21:42
by corvusvideo
I have tried everything I can think of but no luck getting sound except at a rate of 1.0
Can anyone tell me definitively whether I am spinning my wheels here or whether there is some way to do this?
Thanks....
Re: Possible to get audio when axVLCPlugin21.input.rate changes
Posted: 05 Mar 2008 22:47
by Jean-Baptiste Kempf
Only 0.9.0 will play sound if rate != 1.0
Re: Possible to get audio when axVLCPlugin21.input.rate changes
Posted: 06 Mar 2008 13:01
by corvusvideo
Thank you for your reply! I was using 8.6. Thanks again....