The VideoLAN Forums

total sound level and especially speach very low.
in every player, not only vcl

some player allow to configure any codec, audio or video, vcl allow only to configure postprocessing level, but i think its not divx postprocessing level or i cannot see changes.

i can manually run ac3 config and ajust setting, but not in real time, video restart requred.

and i cannot do nothing with a52.

i have laptop and cannot hear nothing.

In VLC make sure you have Stereo enabled (not 5.1).


With AC3filter, make sure you have set your speakers setup to stereo.

yes, stereo enabled.

i need to enter to codec setup.
not only ac3, i want to setup divx too(not very important, but good feature).
online!!! without restarting video.
lots on players allow it.

like this

VLC is NOT a Dshow player... and doesn't use AC3Filter.

sometimes use ac3, sometimes use a52.

but e.g. it use divx - i need to enter divx config

You can't from VLC, because VLC doesn't use DivX, FFDshow or any other directshow codec as j-b said.