Page 1 of 1
No Audio in DirectShow Stream
Posted: 09 Oct 2006 05:57
by NYFan77
I have no audio in my directshow stream
I refreshed to get my soundcard to showup but it will not give an output of the audio. I clicked configure and tried to change input from my "line in" but it will not let me apply this .
Any ideas?
Posted: 10 Oct 2006 07:47
by DJ
If the drivers will not let you switch away from line in then I would expect there should be a cable from the card to the line in for audio. You will need to look at the documentation for your card or contact the manufacturer.
Posted: 12 Oct 2006 02:39
by NYFan77
Well the hardware is not the problem. I have audio in my tv tuning programs but i can't get the sound to stream in VLC even though i selected the sound card.
Posted: 16 Oct 2006 17:24
by cozmo_
Well the hardware is not the problem. I have audio in my tv tuning programs but i can't get the sound to stream in VLC even though i selected the sound card.
Did you find a solution for this ? I'm having the exact same problem and I've spent hours fiddling about with the VLC software, as well as googling my ass off for an answer
Posted: 16 Oct 2006 23:46
by Tikker
same here as well
it worked fine for me in 0.8.4, but not in 0.8.5
mce2005
hauppauge pvr-150 (both the MCE and non mce flavour)
Posted: 17 Oct 2006 20:02
by DJ
As I recall this is a driver issue. Try doing a search here.
Posted: 17 Oct 2006 20:04
by cozmo_
As I recall this is a driver issue. Try doing a search here.
I've tried searching, but there are so many threads on this issue...
Do you think it's the Hauppauge drivers ?