The VideoLAN Forums

Hi
Here in my Country just 4 TV Channel are unencrypt and a Hand full Radio Station (Yes Radio on DVB-T2 not DAB+ ).

So I play around often with the TV Dongle as SDR now now I got the idea test them out with DVB-T2. The TV Card Software run ok.
I got it work! But wait jut when I create an m3u File:

#EXTM3U
#EXTINF:1,TVChannel
#EXTVLCOPT:dvb-bandwidth=8
#EXTVLCOPT:program=
dvb-t://frequency=730000000

Than I can select the Channel or:

#EXTINF:1,Channel1
#EXTVLCOPT:dvb-bandwidth=8
#EXTVLCOPT:program=14107
dvb-t://frequency=498000000

with the PID.

Its perfect for my Project! I want stream on an Wifi the Channels onboard an Bus!
How its possible to Stream the hole Transponder? Here are the Channels:
498000000Hz

T: ORF1 14107
T: ORF2 14108

R: Radio Österreich 1 14109
R: Hitradio Ö3 14113
R: radio FM4 14114

Just 2 TV Channel in SD and 3 Audio Only Radio Channel.

And how to start it by Commandline?! What does "EXTVLCOPT" mean? Where I could find the Parameter for?
Its there an Output possible to indicate the Signal Strenght / Error Rate for an Map?

Sry for Replay what is different between the Option "DVB-T" and "DVB-T2" in VLC? I know it is but not what VLC did if one of them select.