Hi,
I am trying to watch a H.264 file, encoded with MainConcept.
VLC loads it, the sliding bar shows the running seconds, but nothing is being displayed!
I've tried different setting: unsuccessfully!
Any advice is most welcome, thanks,
Best regards,
Carlo
H.264 no video displayed
Forum rules
Please post only Windows specific questions in this forum category. If you don't know where to post, please read the different forums' rules. Thanks.
Please post only Windows specific questions in this forum category. If you don't know where to post, please read the different forums' rules. Thanks.
Dear Moderator,
Thank you for the prompt reply.
Here you can download a sample of the H.264 video.
I am using VLC 0.8.6b and XP SP2 on different hardware, e.g. on dual Xeon 2 GB RAM, notebook etc. What more info can I provide you?
Best regards,
Carlo
Thank you for the prompt reply.
Here you can download a sample of the H.264 video.
I am using VLC 0.8.6b and XP SP2 on different hardware, e.g. on dual Xeon 2 GB RAM, notebook etc. What more info can I provide you?
Best regards,
Carlo
Last edited by CarlO_321 on 14 Jun 2007 10:39, edited 1 time in total.
I don't believe that VLC has compatibility for H.264 in a MPEG PS container. Try MPEG TS.
I the past MainConcepts did not have compatibility to any thing else other than itself. However this was supposed to be resolved in later versions (2.0.15 or higher).
MPlayer does not open your file either, but CoreAVC opens and plays the file normally under Direct Show using MPC.
I the past MainConcepts did not have compatibility to any thing else other than itself. However this was supposed to be resolved in later versions (2.0.15 or higher).
MPlayer does not open your file either, but CoreAVC opens and plays the file normally under Direct Show using MPC.
Return to “VLC media player for Windows Troubleshooting”
Who is online
Users browsing this forum: No registered users and 91 guests