How can I set input and output interfaces in command line?
I try convert hls to udp stream...
vlc -vvv http://77.77.77.77:8080/live/index.m3u8 --sout '#duplicate{dst=udp{mux=ts,dst=233.1.1.1,port=1234}}'
VLC media player 2.1.5 Rincewind (revision 2.1.4-49-gdab6cb5)
Input and Output interfaces
Re: Input and Output interfaces
I must be simple, in old version it was %{iface] after ip-address, now it can be simple
-
Jean-Baptiste Kempf
- Site Administrator
- Posts: 37523
- Joined: 22 Jul 2005 15:29
- VLC version: 4.0.0-git
- Operating System: Linux, Windows, Mac
- Location: Cone, France
- Contact:
Re: Input and Output interfaces
You're missing a lot of info, so that we can help you.
Jean-Baptiste Kempf
http://www.jbkempf.com/ - http://www.jbkempf.com/blog/category/Videolan
VLC media player developer, VideoLAN President and Sites administrator
If you want an answer to your question, just be specific and precise. Don't use Private Messages.
http://www.jbkempf.com/ - http://www.jbkempf.com/blog/category/Videolan
VLC media player developer, VideoLAN President and Sites administrator
If you want an answer to your question, just be specific and precise. Don't use Private Messages.
Return to “VLC media player for Linux and friends Troubleshooting”
Who is online
Users browsing this forum: No registered users and 7 guests