Problem to hear audio from a TV CARD

[glargo]

Hello Everybody....

Well I post this message in others times but... nothing.

I'm using a FlyVideo2000 TV Capture Card chip saa7130 on my Debian System.

Code: Select all

How I know that the TV CARD work?

Easy.... I probe it with xawtv and tvtime and work fun

Following will show you some information about my system

• >> uname -r
  2.6.15-1-486
  
  >> ls -l /dev | grep audio
  crw-rw---- 1 root audio 14, 12 2006-07-18 09:48 adsp
  crw-rw---- 1 root audio 14, 4 2006-07-18 09:48 audio
  crw-rw---- 1 root audio 14, 3 2006-07-18 09:48 dsp
  crw-rw---- 1 root audio 14, 0 2006-07-18 09:48 mixer
  crw-rw---- 1 root audio 10, 135 2006-07-18 09:48 rtc
  
  >> dmesg
  Linux video capture interface: v1.00
  saa7130/34: v4l2 driver version 0.2.14 loaded
  ACPI: PCI Interrupt 0000:02:0a.0[A] -> GSI 22 (level, low) -> IRQ 217
  saa7130[0]: found at 0000:02:0a.0, rev: 1, irq: 217, latency: 132,
  mmio: 0xc0101000
  saa7130[0]: subsystem: 5169:0138, board: LifeView FlyVIDEO2000
  [card=3,insmod option]
  saa7130[0]: board init: gpio is 38500
  saa7130[0]: there are different flyvideo cards with different tuners
  saa7130[0]: out there, you might have to use the tuner=<nr> insmod
  saa7130[0]: option to override the default value.
  input: saa7134 IR (LifeView FlyVIDEO20 as /class/input/input3
  ACPI: PCI Interrupt 0000:00:1f.5 -> GSI 17 (level, low) -> IRQ 225
  PCI: Setting latency timer of device 0000:00:1f.5 to 64
  saa7130[0]: i2c eeprom 00: 69 51 38 01 10 28 ff ff ff ff ff ff ff ff ff ff
  saa7130[0]: i2c eeprom 10: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
  saa7130[0]: i2c eeprom 20: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
  saa7130[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
  saa7130[0]: i2c eeprom 40: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
  saa7130[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
  saa7130[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
  saa7130[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
  Linux agpgart interface v0.101 (c) Dave Jones
  agpgart: Detected an Intel 845G Chipset.
  agpgart: Detected 8060K stolen memory.
  agpgart: AGP aperture is 128M @ 0x88000000
  Floppy drive(s): fd0 is 1.44M
  intel8x0_measure_ac97_clock: measured 50950 usecs
  intel8x0: clocking to 48000
  FDC 0 is a post-1991 82077
  tuner 1-0061: chip found @ 0xc2 (saa7130[0])
  tuner 1-0061: type set to 39 (LG NTSC (newer TAPC series))
  saa7130[0]: registered device video0 [v4l2]
  saa7130[0]: registered device vbi0
  saa7130[0]: registered device radio0
  
  >> lsmod | grep oss
  snd_pcm_oss 45856 0
  snd_mixer_oss 16768 2 snd_pcm_oss
  snd_pcm 77576 3 snd_intel8x0,snd_ac97_codec,snd_pcm_oss
  snd 48612 8
  snd_intel8x0,snd_ac97_codec,snd_pcm_oss,snd_mixer_oss,snd_pcm,snd_timer
  
  >> cat /proc/asound/cards
  0 [I82801DBICH4 ]: ICH4 - Intel 82801DB-ICH4
  Intel 82801DB-ICH4 with AD1981B at 0xc0080c00, irq 225
  
  >> lspci | grep Multimedia
  00:1f.5 Multimedia audio controller: Intel Corporation
  82801DB/DBL/DBM (ICH4/ICH4-L/ICH4-M) AC'97 Audio Controller (rev 01)
  02:0a.0 Multimedia controller: Philips Semiconductors SAA7130 Video
  Broadcast Decoder (rev 01)
  
  So, I hope that this information was ussefull to have an idea of my system....
  
  Now The problem is that when I ran
  >> vlc
  >> v4l:/dev/video0:norm=ntsc:frequency=181000:adev=/dev/dsp:audio=0
  >> --sout-display
  
  I obtein video but not sound.... then i read in the vlc forum about
  saa7134-alsa and i did
  
  >> modprobe saa7134-alsa index=1
  >> dmesg
  saa7134 ALSA driver for DMA sound loaded
  saa7130[0]/alsa: saa7130[0] at 0xc0101000 irq 217 registered as card 1
  
  >> ls -l /dev | grep audio
  crw-rw---- 1 root audio 14, 12 2006-07-18 09:48 adsp
  crw-rw---- 1 root audio 14, 4 2006-07-18 09:48 audio
  crw-rw---- 1 root audio 14, 20 2006-07-18 11:01 audio1
  crw-rw---- 1 root audio 14, 3 2006-07-18 09:48 dsp
  crw-rw---- 1 root audio 14, 19 2006-07-18 11:01 dsp1
  crw-rw---- 1 root audio 14, 0 2006-07-18 09:48 mixer
  crw-rw---- 1 root audio 14, 16 2006-07-18 11:01 mixer1
  crw-rw---- 1 root audio 10, 135 2006-07-18 09:48 rtc
  
  Then i ran
  >> vlc
  >> v4l:/dev/video0:norm=ntsc:frequency=181000:adev=/dev/dsp1:audio=0
  >> --sout-display

And obtein the same.... video but no sound

I really dont know wath do that.... Please help me this is an
important proyect to my college and i dont found solution.

Thanks in advance

Gilberto