HTTP VLM in 0.8.5
Posted: 14 May 2006 18:57
This is a wonderful interface, thanks Antoine.
When sending a batch of VLM commands from the web GUI, it seems like if a "setup name enabled" or "control name play" command is in the batch the enable or play doesn't work.
Also, a "new name broadcast enabled" when sent as a ?command=<cmd>, all URLencoded, sets up the channel but does not enable it.
Where does the limit of 5 inputs come from, and can it be changed?
When editing a destination MRL in the web GUI I check File, and then click the MPEG-TS radio button. The MRL being built in the top field does not now say mux=ts, only mux=. I have to manually make sure the mux=ts is complete.
Could not get the mosaic working with a few UDP MPEG-2-TS.
Intel Mac Mini, 10.4.6, VLC 0.8.5
George
When sending a batch of VLM commands from the web GUI, it seems like if a "setup name enabled" or "control name play" command is in the batch the enable or play doesn't work.
Also, a "new name broadcast enabled" when sent as a ?command=<cmd>, all URLencoded, sets up the channel but does not enable it.
Where does the limit of 5 inputs come from, and can it be changed?
When editing a destination MRL in the web GUI I check File, and then click the MPEG-TS radio button. The MRL being built in the top field does not now say mux=ts, only mux=. I have to manually make sure the mux=ts is complete.
Could not get the mosaic working with a few UDP MPEG-2-TS.
Intel Mac Mini, 10.4.6, VLC 0.8.5
George