Page 1 of 1
Specifying logo parameters with VLM?
Posted: 28 Jul 2005 17:54
by cmosse
I tried these lines:
setup channel1 output #transcode{..,sfilter=logo}.....
setup channel1 option logo-file=/home/kaius/logo/logo.png
..and keep getting "logo private error: logo file not specified" messages..
What am I doing wrong?
Posted: 28 Jul 2005 18:45
by dionoea
try without the "equal" sign after logo-file
Posted: 08 Aug 2005 15:34
by cmosse
try without the "equal" sign after logo-file
Tried it, but didn't change the situation..
Posted: 09 Aug 2005 14:07
by dionoea
i had a look at the source code and its currently not possible to specify the logo-file option using :logo-file (so you can't use it with setup thing option logo-file=... syntax in vlm) I'll change that later today and report back here with a link to a build of the changed version.
Posted: 09 Aug 2005 14:36
by The DJ
Auch, that is bad.
is it now possible?
Posted: 19 Oct 2005 23:34
by dunsti
hello!
is it with the new version (vlc 0.8.2) possible to stream a logo through VLM?
dunsti
Posted: 27 Jun 2006 10:04
by Mellen
This still doesn't seem to work with vlc-0.8.5?
Posted: 17 Jul 2006 14:35
by mheadroom
I can't get this to work either. Anyone know what previous versions supported this or if this will be fixed? I don't see it on the list.
Re: Specifying logo parameters with VLM?
Posted: 19 Aug 2007 09:35
by dynamitemedia
has anyone got this working in this version?
i cant seem to figure it out as well. there is no info in the wiki with the "sfilter=logo"
and the info on the board seems to vary, but i am interested in using this in VLM
as well as where the logo will sit. so ifi need it at 384 and 509 for example in the right hand corner.
any ideas on how to get this to work, i seen in marque you can do position so should be able to with LOGO
but the thing is how to get it to work in VLM
Re: Specifying logo parameters with VLM?
Posted: 02 Jul 2008 16:02
by X-h
Does not work with 0.8.6h neither (?)