The VideoLAN Forums

Hello, we are a charitable institution where bandwidth is at a premium (i.e. we can never afford enough, just a 2MB DSL connection shared by 40 people :( ). A lot of us watch the same mms stream, therefore - to avoid everyone getting the same stream from the internet in order to save bandwidth - I h...

Hi Arite, so I tried the NT service and I can start the service. But the rest of the command line after http (the mms stream and :sout commands) are not taken. So I went to the http interface with my browser and there I only found a "stream output" module where I was able to enter the udp ...

Hi Arite, thank you very much for testing this setup for me. It is working well here too. You are my hero! :D Some users complained that the recording ASF file is now larger than when they were directly recording the (now multicast) MMS stream (and bringing our internet connection to a crawl). There...

Hello, can the above solution help me on an XP station, from which I am trying to multicast an incoming MMS stream which contains WMA to my intranet? :?: The original stream is encoded in wma2 44khz 32kb/s, mono (A/V) 1-pass CBR 16 bits per sample Windows Media Audio 9, video is WMV3, Windows Media ...

Hi Arite, thanks again for your help. That is really what I wanted to do, stream without transcoding. I followed your suggestion, but again, the result was that the clients had no audio, the video was great though. VLC showed in the receiving clients media info only a WMV3 stream, but no audio at al...

Thank you very much for your kind help and quick reply. 192 kps will make for a big bandwidth, which as a charitable organization we are always low on (as well as on funds :)) How do I multicast into an ASF container? I wanted to duplicate the stream, but was not able to do that. Only the MPEG Trans...

Hi, when I try to stream an MMS stream, which comes to our intranet through the outside DSL Internet connection to about 40 internal users via the multicast protocol using the streaming wizard, I was not able to get any sound on my first trial. Then I used these settings: :sout=#transcode{acodec=mp3...