under ubuntu8.04.
whenver i change or say add a printf in my vlc code, previously the make was working fine but now i had to make-clean and then make it again. it wastes a lot of time, if i dont do make-clean the output remains the old one. any quick tip to escape this would be appreciable.
thanks
quick compile and run
quick compile and run
Good one What is H264?
-
Jean-Baptiste Kempf
- Site Administrator
- Posts: 37523
- Joined: 22 Jul 2005 15:29
- VLC version: 4.0.0-git
- Operating System: Linux, Windows, Mac
- Location: Cone, France
- Contact:
Re: quick compile and run
Don't make install and just run a make in the good subfolder.
Jean-Baptiste Kempf
http://www.jbkempf.com/ - http://www.jbkempf.com/blog/category/Videolan
VLC media player developer, VideoLAN President and Sites administrator
If you want an answer to your question, just be specific and precise. Don't use Private Messages.
http://www.jbkempf.com/ - http://www.jbkempf.com/blog/category/Videolan
VLC media player developer, VideoLAN President and Sites administrator
If you want an answer to your question, just be specific and precise. Don't use Private Messages.
Re: quick compile and run
yes, i am not doing make install , i do only make but it doesnt affect the output.Don't make install and just run a make in the good subfolder.
Good one What is H264?
Return to “VLC media player for Linux and friends Troubleshooting”
Who is online
Users browsing this forum: No registered users and 10 guests